Comparing E536 - Potassium ferrocyanide vs E550 - Sodium silicate
Overview
Synonyms
Products
Found in 1 products
Found in 12 products
Search rank & volume
Awareness score
Search volume over time
Interest over time for 3 keywords in U.S. during the last 10 years.
Interest over time for 3 keywords in U.S. during the last 10 years.
Popular questions
How to make potassium ferrocyanide?
It’s produced industrially from iron salts and cyanide chemistry under tightly controlled conditions; do not attempt to synthesize it yourself, and only food‑grade E536 from reputable suppliers is suitable for food use.
How could one ingest potassium ferrocyanide?
You don’t ingest it directly; when permitted, it’s present only in trace amounts as an anticaking agent in table salt (e.g., EU max 20 mg/kg salt), and normal dietary exposure via salt is considered safe.
How many grams of potassium ferrocyanide must be used to prepare 800.0ml of 6.00m solution?
A 6.00 M aqueous solution is not practically achievable due to solubility limits; in theory it would require about 2.03 kg of K4[Fe(CN)6]·3H2O for 0.800 L, which far exceeds what will dissolve.
How to dry potassium ferrocyanide?
Do not heat it to “dry” it—E536 is typically used as the trihydrate, and heating can decompose it and release toxic gases; for food use, simply store the sealed container in a dry place.
How to make .5m potassium ferrocyanide?
Using the common trihydrate, 0.5 M corresponds to about 211 g per liter of solution; this is a laboratory preparation and not a food‑use practice, so it should only be done with appropriate lab controls and PPE.
What is sodium silicate used for?
In foods, E550 sodium silicate is used mainly as an anti-caking/flow agent in dry powders; outside food it serves as a binder/adhesive and deflocculant in detergents, paper, cement, and ceramics.
Is sodium silicate toxic?
At the low levels used in foods it isn’t considered toxic by major regulators, but concentrated solutions are strongly alkaline and can irritate or burn skin, eyes, and the GI tract.
How to use sodium silicate in pottery?
Use it as a deflocculant by adding very small amounts (often with a little soda ash) to clay slip until the desired specific gravity/viscosity is reached; it can also be brushed on and the surface stretched to create crackle textures—wear gloves and avoid over‑addition.
Is sodium silicate safe for skin?
Undiluted or moderately concentrated sodium silicate is not skin‑safe because it’s caustic; only very dilute formulations (as in some cosmetics) are used on skin, and even then may cause irritation in sensitive individuals.